Error code
Thermador dishwasher error code E0103
Thermador error code E0103: a relay on the main control board is not switching. What the code covers, what to check first, and what it does not tell you — on dishwashers.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code E0103, from the manufacturer's own documentation
A code is only meaningful together with the machine showing it — the same digits mean different things on different equipment.
The code
E0103
A relay on the main control board is not switching
or call (305) 846-7685
What it narrows down to
Board relay
What you are probably seeing
Diagnostic
From $95, credited to the repair
What it looks like from the kitchen
The symptom this code usually arrives with
A code names the subsystem; the symptom is what sent you to look at the display in the first place. That page says what it usually turns out to be, cheapest cause first.
-
Often a protection Dishwasher will not start
A machine with lights on that will not run, or one that shows nothing at all. On this platform a machine that refuses to start is usually protecting itself, and the code says which protection.
- Lights on, nothing happens
- A code showing before the cycle begins
- Dead panel, no lights at all
On the same appliance
What else belongs to the dishwashers
On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this appliance can display
Flow meter
No water arriving
Water level too low
Water in the base
Filter blocked
Drain blocked
Drain pump
Drain pump circuit
Heater electronics
Limescale in the heat pump
Heat pump heater
Heat pump blocked
The same digits mean different things on different equipment. Search the full code list
In more detail
About Thermador dishwasher error code E0103
What this one means
A relay on the main control board is not switching.
The other ways your machine may say it
The same condition is published under more than one label, because it has been carried across generations of this appliance:
- E0103, E0107 — the same condition, on machines of different ages
What the code covers
A published cause names a circuit rather than a component, which is the single most useful thing to know before ordering a part. This one covers:
- The relay
- The board it is soldered to
Worth doing before you call
- Cut power at the breaker for thirty seconds
Then what
A relay is not replaced on its own here; the board is the part.
This code is published for dishwashers. The full list of codes has the rest.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards